Licensed NSW electrical contractor · Licence 270174CCall John 0417 297 285
Electrical3 Call now
EV charger installation · Curl Curl 2096

EV charger installation in Curl Curl, from $1,653.

Home EV charger installation in Curl Curl, priced before we start. Electrical3 is based in Cromer, minutes from Curl Curl, and fits home chargers across the Northern Beaches every week. Supplied and installed, including GST, with the certificate of compliance.

NSW Licence 270174C25-year workmanship guaranteeFixed price before we startBased in Cromer

What an EV charger costs in Curl Curl

Every figure is the fixed price we install for, including GST — not a range you find out the truth about later.

EV charger installation prices in Curl Curl, including GST
Install typePrice inc GSTWhat moves it
Single phase 7.4kW, charger supplied and installed$1,653Based on a 10 metre run from the switchboard. Longer runs are priced by the metre.
Charger you already own, installedfrom $893We confirm the unit suits your supply before we quote it.
Three phase, up to 22kW$2,032Needs three phase already at the property, and a car that can accept it.
Solar-diverting charger$2,163Only chargers that genuinely divert solar. We will not sell you one that cannot.
Surge protection added on the day$397 single phase
$638 three phase
Cheapest while the board is already open, rather than a separate call-out.
Switchboard upgrade, if the board has no roomQuoted before we startOlder boards with ceramic fuses and no safety switches. Send a photo and we price it up front.
Prices current September 2026. Certificate of compliance with every job, and a 25-year workmanship guarantee. Get your exact figure in four questions →

Charging at home in Curl Curl

Most homes here have an attached garage or carport close to the board, which usually keeps an EV charger install straightforward.

Beachside, exposed, and a mix of original homes and modern rebuilds. Salt reaches the external fittings here, and the older housing stock still carries the pre-RCD switchboards that make a straightforward upgrade one of the most worthwhile things an owner can do.

Housing here is post-war brick and fibro homes, many renovated or extended, alongside newer townhouses and duplexes, and that is what decides the job: where the board sits, how far the car parks from it, and what the supply already carries.

What we run into in Curl Curl

Home EV charger installed at a Curl Curl house

What the price covers

The board, first

Before anything is mounted we check what the board can carry. The charger then gets a dedicated circuit and its own protection, rather than being hung off a spare way.

The route

Measured on site, run in conduit and made good behind us. A long run costs more and a short one costs less, because the price follows the actual distance.

Installed and signed off

Terminated, current limited to what your supply can carry, tested and commissioned — with the compliance certificate issued and the mess taken away.

Not what is in the van

The right charger depends on your solar, your car and your switchboard. We work through all three with you rather than fitting whatever we happen to carry.

We install Tesla Wall Connector, Zappi, Wallbox, Ohme, Evnex and other leading brands, and we will fit a charger you have bought yourself once we have confirmed it suits your supply. See the full EV charger page →

EV charging in Curl Curl, answered

How much does an EV charger cost to install in Curl Curl?

A single phase 7.4kW charger supplied and installed is $1,653 including GST, based on a 10 metre run from the switchboard. Fitting a charger you already own starts at $893, three phase is $2,032 and a solar-diverting charger is $2,163. The estimator on our Sydney EV page gives you your own figure in four questions.

Do you install EV chargers in Curl Curl?

Yes. Electrical3 is based in Cromer, minutes from Curl Curl, and EV charger installation is work we do across the Northern Beaches every week. Call John on 0417 297 285.

What is different about installing a charger in Curl Curl?

Most homes here have an attached garage or carport close to the board, which usually keeps an EV charger install straightforward. Beachside, exposed, and a mix of original homes and modern rebuilds. Salt reaches the external fittings here, and the older housing stock still carries the pre-RCD switchboards that make a straightforward upgrade one of the most worthwhile things an owner can do.

Will my switchboard need upgrading first?

Sometimes. A charger needs its own circuit with its own RCBO, and older boards with ceramic fuses and no safety switches often have no room for one. We check the board before quoting, and if it needs work you are told the price before anything starts.

Do I need three phase to charge at home?

Not for most people. Single phase at 7.4kW puts back 35 to 50km an hour, so a normal day of driving is replaced overnight. Three phase is worth it only when the property already has it and the car can use it.

How long does the installation take?

Most single phase installs are a single visit, two to four hours, tested and certified before we leave. A long run, board work or a strata building adds time and we tell you that at quoting stage, not on the day.

What people say ★★★★★

Rated 5.0 from 20 Google reviews. Read them all on Google.

★★★★★
“Just got my EV wall box installed by John from Electrical3. He had been excellent from the moment he gave the quote right down to the end of Installation. Honest bloke, Professional and Fair price.”
LWR27Local Guide · Google review

EV charger installation nearby

Also general electrical work in Curl Curl, or every suburb we cover.

Call John — 0417 297 285