Ten halogens swapped for LED in Narraweena, installed, for a price you know before we start. Electrical3 is based in Cromer, minutes from Narraweena, and this is work we do across the Northern Beaches every week.
Every figure below is what we install for, including GST.
| What | Price inc GST | What it covers |
|---|---|---|
| 10 downlights swapped | $584 | About $58 a light, including GST and fully installed. |
| 20 downlights swapped | $1,096 | The price per light falls as the number rises — the access and setup are done once. |
| Your exact number | Priced on the page | The calculator on our lighting page gives your figure as you move the slider. |
| Dimmers matched to the new lights | Quoted with the job | Old halogen dimmers rarely work properly with LED and are best changed together. |
| Outdoor and undereave lighting | Quoted on site | Worth doing in the same visit while the ladders are already out. |
Post-war brick and fibro homes that were re-lit in the 2000s, when halogen downlights were what everyone put in. Those fittings are now the single biggest easy saving in the house, and the swap is a morning's work rather than a rewire.
Quiet post-war residential on the hill, largely unrenovated brick and fibro homes. It is a suburb where the electrical work is predictable and worth doing properly: original switchboards, no RCD protection, and lighting circuits that have carried added downlights they were never designed for.
50W halogens still running with their transformers above the ceiling
Insulation pulled back around old fittings, which an LED lets you put back
Dimmers that were matched to halogen and will need changing with the lights
Ten swapped from 50W halogen to LED is $584 including GST, fully installed — about $58 a light. Twenty is $1,096. The calculator on our lighting page prices your exact number as you move the slider.
Usually yes. The access, the setup and the travel happen once, so the price per light falls as the number rises. If you are going to do it eventually, doing it in one visit is the cheaper way.
Post-war brick and fibro homes that were re-lit in the 2000s, when halogen downlights were what everyone put in. Those fittings are now the single biggest easy saving in the house, and the swap is a morning's work rather than a rewire. Quiet post-war residential on the hill, largely unrenovated brick and fibro homes. It is a suburb where the electrical work is predictable and worth doing properly: original switchboards, no RCD protection, and lighting circuits that have carried added downlights they were never designed for.
Almost never. Most halogens are a 90mm cut-out and the LEDs go straight into the same hole. Where a ceiling has an odd size we match it rather than enlarging it, which matters in older and heritage ceilings.
They come out. Leaving them in the ceiling is the shortcut that gets taken and it is both a heat problem and a waste — an LED does not need one. The old fittings and transformers leave with us.
Ten lights is a morning. The old ones come out, the new ones go in, and the room is left as it was found. Every job gets a certificate of compliance.
Rated 5.0 from 20 Google reviews. Read them all on Google.
“I have used John from Electrical 3 for many years now. He always does a fantastic job with no fuss. I can always rely on his prompt service and reasonable rates.”
Also switchboard upgrades in Narraweena and EV charger installation. Or general electrical work in Narraweena.
