Licensed NSW electrical contractor · Licence 270174CCall John 0417 297 285
Electrical3 Call now
EV charger installation · Clontarf 2093

EV charger installation in Clontarf, from $1,653.

A real price for a home charger in Clontarf, before anyone comes out. Electrical3 is based in Cromer, minutes from Clontarf, and fits home chargers across the Northern Beaches every week. Supplied and installed, including GST, with the certificate of compliance.

NSW Licence 270174C25-year workmanship guaranteeFixed price before we startBased in Cromer

What an EV charger costs in Clontarf

Every figure is the fixed price we install for, including GST — not a range you find out the truth about later.

EV charger installation prices in Clontarf, including GST
Install typePrice inc GSTWhat moves it
Single phase 7.4kW, charger supplied and installed$1,653Based on a 10 metre run from the switchboard. Longer runs are priced by the metre.
Charger you already own, installedfrom $893We confirm the unit suits your supply before we quote it.
Three phase, up to 22kW$2,032Needs three phase already at the property, and a car that can accept it.
Solar-diverting charger$2,163Only chargers that genuinely divert solar. We will not sell you one that cannot.
Surge protection added on the day$397 single phase
$638 three phase
Cheapest while the board is already open, rather than a separate call-out.
Switchboard upgrade, if the board has no roomQuoted before we startOlder boards with ceramic fuses and no safety switches. Send a photo and we price it up front.
Prices current September 2026. Certificate of compliance with every job, and a 25-year workmanship guarantee. Get your exact figure in four questions →

Charging at home in Clontarf

Apartment charging usually means a conversation with strata and a metered supply from the right board — solvable, but not a same-day job.

Harbour beach with steep blocks running down to the water. Long runs to lower levels, boatsheds and waterfront lighting are routine, and while it is harbour rather than surf, it is still a marine environment for anything mounted outside.

Housing here is Federation semis and cottages mixed with 1960s and 70s walk-up apartment blocks, and that is what decides the job: where the board sits, how far the car parks from it, and what the supply already carries.

What we run into in Clontarf

Home EV charger installed at a Clontarf house

What the price covers

The board, first

Before anything is mounted we check what the board can carry. The charger then gets a dedicated circuit and its own protection, rather than being hung off a spare way.

The route

Measured on site, run in conduit and made good behind us. A long run costs more and a short one costs less, because the price follows the actual distance.

Installed and signed off

Terminated, current limited to what your supply can carry, tested and commissioned — with the compliance certificate issued and the mess taken away.

Not what is in the van

The right charger depends on your solar, your car and your switchboard. We work through all three with you rather than fitting whatever we happen to carry.

We install Tesla Wall Connector, Zappi, Wallbox, Ohme, Evnex and other leading brands, and we will fit a charger you have bought yourself once we have confirmed it suits your supply. See the full EV charger page →

EV charging in Clontarf, answered

How much does an EV charger cost to install in Clontarf?

A single phase 7.4kW charger supplied and installed is $1,653 including GST, based on a 10 metre run from the switchboard. Fitting a charger you already own starts at $893, three phase is $2,032 and a solar-diverting charger is $2,163. The estimator on our Sydney EV page gives you your own figure in four questions.

Do you install EV chargers in Clontarf?

Yes. Electrical3 is based in Cromer, minutes from Clontarf, and EV charger installation is work we do across the Northern Beaches every week. Call John on 0417 297 285.

What is different about installing a charger in Clontarf?

Apartment charging usually means a conversation with strata and a metered supply from the right board — solvable, but not a same-day job. Harbour beach with steep blocks running down to the water. Long runs to lower levels, boatsheds and waterfront lighting are routine, and while it is harbour rather than surf, it is still a marine environment for anything mounted outside.

Will my switchboard need upgrading first?

It depends what is in the board now. Ceramic fuses, no safety switches or no spare ways usually mean an upgrade first. We look at that before pricing the charger, so there is no mid-job surprise.

Do I need three phase to charge at home?

Not for most people. Single phase at 7.4kW puts back 35 to 50km an hour, so a normal day of driving is replaced overnight. Three phase is worth it only when the property already has it and the car can use it.

How long does the installation take?

A straightforward single phase install is usually done in one visit of two to four hours, including testing and the certificate of compliance. Longer cable runs, switchboard work or strata buildings take longer, and we say so when we quote.

What people say ★★★★★

Rated 5.0 from 20 Google reviews. Read them all on Google.

★★★★★
“Just got my EV wall box installed by John from Electrical3. He had been excellent from the moment he gave the quote right down to the end of Installation. Honest bloke, Professional and Fair price.”
LWR27Local Guide · Google review

EV charger installation nearby

Also general electrical work in Clontarf, or every suburb we cover.

Call John — 0417 297 285